⚡ Ford Lightning Forum ⚡ banner
1 - 2 of 2 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter · #1 ·
Just finished my radar detector and dash cam hardwire installation. I thought I’d share the information in case others find it useful.

-Escort/Beltronics radar detector powered using mirror tap
-Garmin Dash Cam Mini 2 powered using Garmin’s hard wire kit using fuse taps from the passenger footwell area

Parts used:
Mirror tap for Escort
Garmin parking mode hardwire kit
Some micro 2 fuse taps which I already had in my garage

I wish I could have just powered the dash cam from the mirror as well but Garmin needs a 3-wire power module to automatically switch between driving mode and parking mode. This module wouldn’t fit behind the mirror. So I ran the wire behind the passenger side door seal down into the fuse box located at the passenger footwell.

Mirror tap was very easy, I used the thinner prongs and got accessory power from the black and green wires. Counterintuitively, the black wire seems to be positive, go figure.

For the dash cam power module, I found two 20A fuses that are “spare” according to the manual. They are:
#4: permanent 12V
#37: accessory 12V
Ground was easy, there is a bolt just at the edge of the carpet.

Main goal was to keep these units out of sight and I’m pretty happy with the results!

Vehicle Automotive lighting Automotive mirror Window Automotive design


Mirror Vehicle Car Hood Automotive lighting


Motor vehicle White Automotive design Automotive tire Bicycle handlebar

Automotive tire Automotive design Electrical wiring Cable Wire


Flash photography Tints and shades Door Darkness Font
 
1 - 2 of 2 Posts
Top