I'm thinking you might go buy a lottery ticket, your chances of winning the big pot are better than Ford implementing this anytime soon. We are lucky to get a few bugs fixed and to get PAAK working for all trucks. Hope that will happen soon.I find it quite maddening that with all the cameras in this truck, one still has to install an aftermarket dash cam. Super hoping this gets rectified before I take delivery.
Radar detector and dash cam install
Just finished my radar detector and dash cam hardwire installation. I thought I’d share the information in case others find it useful.
-Escort/Beltronics radar detector powered using mirror tap
-Garmin Dash Cam Mini 2 powered using Garmin’s hard wire kit using fuse taps from the passenger footwell area
Parts used:
Mirror tap for Escort
Garmin parking mode hardwire kit
Some micro 2 fuse taps which I already had in my garage
I wish I could have just powered the dash cam from the mirror as well but Garmin needs a 3-wire power module to automatically switch between driving mode and parking mode. This module wouldn’t fit behind the mirror. So I ran the wire behind the passenger side door seal down into the fuse box located at the passenger footwell.
Mirror tap was very easy, I used the thinner prongs and got accessory power from the black and green wires. Counterintuitively, the black wire seems to be positive, go figure.
For the dash cam power module, I found two 20A fuses that are “spare” according to the manual. They are:
#4: permanent 12V
#37: accessory 12V
Ground was easy, there is a bolt just at the edge of the carpet.
Main goal was to keep these units out of sight and I’m pretty happy with the results!
![Vehicle Automotive lighting Automotive mirror Window Automotive design]()
![Mirror Vehicle Car Hood Automotive lighting]()
![Motor vehicle White Automotive design Automotive tire Bicycle handlebar]()
![Automotive tire Automotive design Electrical wiring Cable Wire]()
![Flash photography Tints and shades Door Darkness Font]()
-Escort/Beltronics radar detector powered using mirror tap
-Garmin Dash Cam Mini 2 powered using Garmin’s hard wire kit using fuse taps from the passenger footwell area
Parts used:
Mirror tap for Escort
Garmin parking mode hardwire kit
Some micro 2 fuse taps which I already had in my garage
I wish I could have just powered the dash cam from the mirror as well but Garmin needs a 3-wire power module to automatically switch between driving mode and parking mode. This module wouldn’t fit behind the mirror. So I ran the wire behind the passenger side door seal down into the fuse box located at the passenger footwell.
Mirror tap was very easy, I used the thinner prongs and got accessory power from the black and green wires. Counterintuitively, the black wire seems to be positive, go figure.
For the dash cam power module, I found two 20A fuses that are “spare” according to the manual. They are:
#4: permanent 12V
#37: accessory 12V
Ground was easy, there is a bolt just at the edge of the carpet.
Main goal was to keep these units out of sight and I’m pretty happy with the results!
