[partyofone]

My frunk is open. There is nothing I can do to close it.
When I press the button it does 2 long beeps - pause - 2 long beeps.
I tried to shut it manually but it doesn’t latch. There is no error message on the screen, other than the funk being ajar.
I’m at wits ends. Any tips?

 

[partyofone]

Nevermind. Problem resolved.
It’s a bit of a software bug.
So earlier today, the frunk was wide open, and I pulled the fuse while working on the dash cam. After I reinstalled the frunk fuse, and the system rebooted, the truck “assumed” that the frunk was in the close position. So each time I pressed the button it was trying to open it, not realizing it was already open.
The solution: I pulled the manual latch, then manually forced the frunk shut. At this point, it was in the position the truck was assuming (closed). Upon pressing the button again, it opened just fine. Now it’s working.
Kind of a dumb software implementation (the frunk state not being tracked).

 

[null98115]

I pulled the fuse while working on the dash cam.

Thanks for the post explaining this.